I felt this is not camera is not right and could you guys please help tp see it, I had calibrated IMU, Compass and the controller after the firmware updated since i bought it 6 days ago.
Almost everyflight i have seen this issue.
Bought it in applestore HK, should I go back and ask for exchange or to DJI store flagship?
If you make abrupt stops that may happen. For filming you need to fly more smoothly. You can lower the sensitivity of the Braking and Attitude.
Main Controller Settings, Advanced Settings, then Sensitivity.
Also look at the gimbal and make sure all 4 corners are suspended correctly.
DJI-Ken Posted at 2017-1-6 10:47
If you make abrupt stops that may happen. For filming you need to fly more smoothly. You can lower the sensitivity of the Braking and Attitude.
Main Controller Settings, Advanced Settings, then Sensitivity.
Also look at the gimbal and make sure all 4 corners are suspended correctly.
thank you for replying, I'm sure that some of my shots were just flying forward or descending.
DJI-Ken Posted at 2017-1-6 11:38
You can also try restoring to factory settings from the Assistant2.
Or also refreshing the firmware.
Hi,
I am new to drones and having the same gimbal twiches.
Got my Mavic on 3th of Januari, upgraded the firmware (drone and controller) and did some flying. All good. To day I did my first filming and noticed a twitch every 3 seconds or so . I did a gimbal calibration but that did not help.
Did restoring to factory setting helped you?
same result. I think it got worst day by day, i can see more jello effect at the beginning before flying.
If your gimbal is suspended correctly of all four corners and the troubleshooting steps did not resolve it then you may have to send it in for evaluation. http://www.dji.com/support/product
pokemon Posted at 2017-1-8 06:08
No, it didn't help, I think I will have to get a replacement for this, waited for so long, and have to wait again. BAD LUCK!
If your gimbal is suspended correctly of all four corners and the troubleshooting steps did not resolve it then you may have to send it in for evaluation. http://www.dji.com/support/produc
DJI-Ken Posted at 2017-1-8 11:57
If your gimbal is suspended correctly of all four corners and the troubleshooting steps did not resolve it then you may have to send it in for evaluation.
http://www.dji.com/support/product