Quadrocopter
lvl.2
Flight distance : 250125 ft
United States
Offline
|
Tried calibrating the landing gear on a customer's M600 because it would go up, pause, and then go back down. Tried calibrating twice, both resulted in a solid Yellow LED (Failure). On the third time I got a solid Red LED (Motor stalled). I tried again a fourth time after double checking everything, and now I get no LED at all.
Upon power up, I get a quick twitch from the right gear, and then nothing. No LED, no humming.
Tested the output from the A3, and it functions normally with the remote switch. None of the F1-8 ports however supply any voltage. The Yellow XT connector supplies 6S power.
I attached the landing gear module's input to a seperate Spektrum reciever mapped to a switch, no dice either.
I'm assuming I have a bad landing gear module, but is there a reset procedure just in case. Currently on hold with DJI and hoping I can get a replacement landing gear controller board rather than shipping a working M600 with jobs lined up.
-Chris
|
|