The following (see video) has started occuring on my Mavic. I have not crashed it into anything. Reloading the latest firmware, calibrating the IMU, VPS does not seem to fix it. Happens both outside (GPS) and inside (opti/atti). DJI Go reports 'abnormal gimbal vibration', but as you can see, It's not the gimbal its the entire craft.
At first I thought it was the propellers, but I swapped those out, and the problem is still there.




I have flight logs too and can PM a dropbox link if someone knows how to interpret them...

Any suggestions before I call DJI and RMA it?

Turn off the prop guard (cage) option. I dont have my mavic with me but dig into the menus for prop guards.

in settings you probably have prop guards enabled . it is quiet common , it checks itsef after some updates

QuanthonyTrang Posted at 2017-1-10 16:29
Turn off the prop guard (cage) option. I dont have my mavic with me but dig into the menus for prop guards.

Thanks so much! That worked immediately. DJI Chat support only suggested obstacle avoidance system calibration again....

QuanthonyTrang Posted at 2017-1-10 16:29
Turn off the prop guard (cage) option. I dont have my mavic with me but dig into the menus for prop guards.

I have to ask - what is the "Prop Guard" option and what does it do?

samg Posted at 2017-1-10 17:16
Thanks so much! That worked immediately. DJI Chat support only suggested obstacle avoidance system calibration again....

Where do you turn off prop guard option

fans7da3e30b Posted at 2017-1-28 20:21
I have to ask - what is the "Prop Guard" option and what does it do?

Maybe DJI will issue prop-guards which change the aerodynamics of Mavic substantially. Then this function might compensate the (radically?) changed airflow through the props ?

Same happened with me and turning off props guard fixed the issue. It may be activated when I turned off beginner mode. Thanks a lot for the solution