Skyclip
lvl.4
Flight distance : 347940 ft
Germany
Offline
|
I had a huge real estate shoot near an Airport with my Inspire RAW and P4P yesterday, with some
really annoying issues with GEO/flysafe.
Paperwork and Communication with DJI Flysafe to fly in restricted Zones was really great, no Problems.
To fly in restricted Zone, you get some kind of file sent to your DJI Go App, you have to activate it and tap a switch
to unlock.
BUT, there the Crap starts:
It was a tight environment, Two big Buldings with a small street in between, no GPS reception.
So, it is not possible to unlock the restricted Zone instantly, due to no GPS.
App says VPS Mode, go.
As soon as you start and go up, the Drone gets GPS reception and says "Restricted Zone, Auto Landing".
It simply starts landing, and if youre not fast enough in tight environments to maneuver it to a safe spot you will simply crash the drone.
After Auto Landing, same problem. No GPS reception, so no unlock possible.
So, i had to move a long way out of the street to get GPS. Then unlock and fly or carry the drone all the way back to the place where
you wanted to take the scene.
That would be OK, if it would be needed only one Time for the given Timeframe you can ask for at DJI flysafe.
No, everytime you switch off the Drone for changing battery, the Game starts again.
Thats really annyoing, time and battery waste. I had to do it 7 Times that day.
P4P flying from indoor to outdoor, the same. Auto-Landing.
Best was, some kind of "passage" where i was flying through.
GPS reception, unlock. OK. Flying in the passage, no GPS. OK, works. Flying outside again, annoying message start popping up where
i have to accept again flying in restricted zone. OMG.
DJI, it could be so simple.
Unlock the restricted Zone for the given time ONCE and it STAYS in flight controller for the given time.
Please change that.
I will also send that to flysafe via EMail.
|
|