Hi, im so terrible! Is there anyone out there in New Jersey that would be willing to put this back together for me? I just have to get all the wires solderd back together after a shell replacement I just dont have the patients for it.. thanks

Just to clarify, you replaced the shell by yourself, right?
Here are the repair centers for your reference, hope that helps: http://www.dji.com/service/repair/centers
If it cannot be solved by the local repair centers, then it needs to be sent in to DJI official repair center, you can submit a case and apply for pickup online: https://repair.dji.com/en/SelfRepair/Area

Aloha fans26,

     A shell replacement does not require soldering.  But since you are already there, there are micro crimping options that are much easier than soldering for open wires.  If you pulled wires off of a board, you may be screwed.  But, hey, there are many soldering videos on YouTube that show you how it is done properly and easily.  If it was not easy, many people would not do it.  You may have to give it a shot.  Practice on spare and defunct parts.

     Hope this helps!

Aloha and Drone On!