I'm new to Phantom flying and am excited to start, but, unfortunately, am grounded before I even took my first flight. I did research via multiple areas and couldn't find an answer that applies.

I just received a new Phantom 4 Pro+. Upon turning it on, I was prompted to upgrade the controller and drone firmware. I did both and both ran through succesfully. After that, the app indicates that IMU Calibration must be completed prior to flying. I followed the prompts and started the IMU Calibration, although the  indicator says "Gimbal cannot receive MC data" . And upon selecting "IMU calibration" a message saying "disconnected" appears briefly and nothing happens . It won't proceed even after letting it sit for 10+ minutes. The drone's light turned red after several attempts .

I tried powering everything off and restarting IMU calibration several times, including after letting it cool off. Nothing is allowing me to do the calibration.Here are some pictures, hoping you can help me

Hope you are enjoying the beautiful beaches in Tunisia.!

These are the steps that I did for the initial setup after unboxing. Good Luck and let us know.

http://forum.dji.com/thread-76002-1-1.html


These are the steps after latest update (few days ago).

http://forum.dji.com/thread-81314-1-1.html