stefan.intarq
New
Chile
Offline
|
Saved As the Mather fact you could change the value of 30% and the 10% when starts descending wherever it is. In the advanced mode.
That 10 should last to put it down from 500m. But it should be able to squeeze it more in case of emergency.
I was doing a fly away test, I toke it to 500 M high then flow it away up tu 2,6 km , 1.62 miles, then as I was still pushing it away with not bad camera reception, at exactly 51% it started automatically go home function, I though well i toke it of first (500)so it will have enough to come back, but in fail safe it flew as slow as hell, so it chewed up every drop of power and started to descend almost 600m away from me, it was a torture to find a place to land, because it behaves different, like drunk, so as I could I directed it to the middle of football stadium and lost signal when it passes the roof, TI happens to land in the middle of a game, I found that better than landing it there than on any street. It toke me 7 minutes to get there and lukily a player passed the inspire back to me. It's all recorded. Lesson: fly back fast, almost all power is used to lift those pounds, flying slowly is almost the same as fling fast, it's not a plane.
Then again in other occasion I had the fail safe mode activated and could not control it to get back home, this time it felt on grass, 100 m away, but it landed hard, so hard the gimbal was ejected 3 m away and found cuadracopter upside down, I think it could not determine the high right, and as it was turned the propellers wanted to put the inspire back on his feet but the propellers Where not able as they where blocked with gras and got overheated, too overheated. :@ Lost 2 motors. My reseller told me dji does not Change motors.
I'm sure if fail safe mode had not intruded in my flight it could have turned home in both cases.
|
|