I purchased my Phantom 4 a few weeks ago. I had a little crash landing today and had to replace one of the props. After I turned the drone back on and reconnected to the app, I got a firmware update error message. First it required the drone updated then the controller. As soon as both were updated (took all afternoon) I got an ESC 1, 2, 3, and 4 error.  Then I got an error the gimball is overloaded but on the app it works fine. All messages say the drone cannot take off,
Any thoughts. I did 3 or 4 restarts of the app and the drone and the issue did not go away. Only happened after the firmware updae. Please want to fly today!!


Thanks for the help. Ed

Try an re install the firmware using dji assistant 2 on computer.

Please try Vantis' advice when you can. In addition, try restoring the unit to factory settings via the Assistant 2 as well.