Hawk62_Engineer
New
South Africa
Offline
|
Hey Fans
So we had a simmilar application with our M600 Platform.
We needed to use an Optical camera and a Thermal camera, triggering at the same time with the same gimbal pitch angle.
After lots of fustration with LB2 not being able to dual feed video and the A3 F-ports funtionality not happening, we decided to use a STM board and tapped into the SDK for the additional features.
We now have a Rx100 optical camera and a Flir Thermal camera on a single gimbal. The trigger functions are fired from the STM board.
The dual video feed was also tricky as the LB2 can only Picture in Picture with a DJI gimbal and either the AV or HDMI source. We ended up running a Relay on the video and feeding the LB2 with 1 AV source and used the STM board to switch the relay, which switched the video source from the Optical or the thermal camera.
Running dual gimbals off a single Simple BGC board is most probably not do-able.
For accuracy I would suggest a single gimbal with both cameras mounted, should also help with post processing.
Hope this helps!
Regards
|
|