Hazardpro1
lvl.2
United Kingdom
Offline
|
Hi thanks for the reply.
So at first the gimbal was completely dead (didnt even power up) and in the app I just has a 'upgrade gimbal firmware' notice.
Now (after lots of whapping stuff around, unplugging and pluggin in again, updating and reupdating firmwares the Gimbal powers up, does its rotating thing, then goes limp, and starts beeping.
In app it says 'gimbal not connected'
On LB2 the video light is red.
X3 is unchanged and still on latest OSMO firmware (ps the X3 still works fine when connected on the OSMO)
So far ive tried a different X3 camera
Different leads to the LB2 > X3
Different Matrice mounting kit
Im able to downgrade the firmware on LB2 air unit, but the ground unit does not give me any downgrade options via the App (it only lists the latest version) so Im stuck on the latest version.
Ive since physically removed the channel expansion kit from the LB2 unit now, but im still unable to downgrade the firmware.
Only thing left I havent tried is to hook up another LB2 unit.
H
|
|