rogiervdheide
lvl.4
Liechtenstein
Offline
|
It's an old thread but I encountered the problem today so here is the solution.
When the RC and the AC do not connect, there is a firmware mismatch. I updated the firmware on the Lightbridge 2 of my Matrice 600 Pro and could not connect anymore. I also updated the RC and then I, of course, lost track of what I had updated, which versions, and so on.
I made it all work again by having v1.1.81 firmware on the LightBridge 2 Air System and v1.2.52 on the Remote Controller.
And now I will tell you a secret that DJI does not tell you:
Using your Android or iOS device, you can roll back the firmware of your remote controller.
Launch the DJI GO app without having your phone or tablet connected to the RC. Right after the splash screen, in the screen where you choose an aircraft, there is a hamburger menu icon in the top right corner. Tap and hold this icon for three seconds, release and a black screen pops up that allows you to pick a firmware version and install it on your RC. It take 10 - 15 minutes, do wait until the process has completed.
See my screen shots.
|
|