Loganx1121
United States
Offline
|
Update again: So I got home, connected to the DJI assistant 2 app and did a camera calibration. Idk if that calibrates the gimbal or not actually but I figurd it couldn't hurt. (Does it cal the gimbal or just the 2 front avoidance cameras?) Then I calibrated the IMU even though it said those sensors were fine. Took it outside in the driveway, put it sport mode, did a bunch of left to rights and yaw rotations and really wasn't seeing the horizon tilt anymore.
BUT, and this is a new one for me, I had it landed and the motors going while I was messing with the app, and got a gimbal motor overload error. It was just sitting in the driveway, motors on, not moving while I was playing with some of the settings (not gimbal settings either) and up popped the gimbal overload error. I have no clue. Any ideas?
No the gimbal bracket was not on, and there was very little wind.
|
|