userf457687615
New
Russia
Offline
|
Hi all! I have same problem with my mavic pro.
I bought a used Mavik. Before buying, I checked it, it was all ok and the green bar on top - ready to go.
When I brought it home, I found an error - system vision error. The only thing I did with it in the car while driving home - is powered on it in a box with a gimbal lock, to check the connection to my phone. Perhaps it overheated.
I wrote a request to the DJI support service and they said - send it to our service center to Germany for warranty repair. The problem is that I live in Russia and our "wild" customs do not want to pass quadrocopters across the border. And creates for this bureaucratic obstacles.
I tried to calibrate the sensors in the DJI assistant2, but where there should be a picture from the sensors there were just gray screens - no image was from sensors..
I flew about 20 times with this error and once during the flight the error was gone. I landed the Mavik, turned it off and took it home to calibrate in the DJI assistant. But at home this error of the vision system appeared again.
In general, I gave the Mavik to a local service center for diagnostics.
They said that it is necessary to change the sensor control board and the sensors themselves. They said this is a small board that is in the head of the mavik, above the gimbal.
I tried to find this board at local DJI dealers, it turned out that board is assembled only with a gimbal and costs 1/3 of the price of the mavik. And they told If you put a board not from the native gimbal, the gimbal will not work.
As a result, I had a few question - are they right in the local service center?
Are the sensors working on the board from the gimbal?
After all, the gimbal itself works normally. Why does the vision system not work on this board, and the gimbal on this board works?
Can anyone suggest alternative opinions because of an error in my movie?
Thanks and sorry for long post on bad English) |
|