MikeQView
lvl.4
United Kingdom
Offline
|
just updated, first the new version of DJI Assistant 2 1.10 , and then the Tx and Mavic, things found below.
a) Assistant 2 pc v 1.10.0 updated fine no issues
b) Tx , the USB connection is really flakey, flicking in and out of connection terribly, tried lots of different cables just to prove it wasnt a cabling issue,eventually got it to connect, then appeared to go through no problem, but with one USB disconnect.
c) The Mavic failed its upgrade at 50% (on screen warning, failled, at the part where it should have rebooted) so rerun the upgrade and it all went well on the second attempt, i really hate failled upgrades and this is the first time on any of its upgrades it has done this, when i powered the mavic up after this, i had no camera, either picture on mobile device or in the menu? powered down, and power up with every thing working fine, again, i hate this hit and mis approach to flying machines, DJI please , please stabalise your firmware and softwares ! ! ! after this, going through each of the menus sees a few subtle changes, still here maps, still no art mode, batteries didnt pull an upgrade either since .200
Calibrated everything except compass ( do that at the flying field ) i would have felt that much more at ease with this process if it didnt fall over, especially as i can see no way back below .200 if .000 was still there i would have taken it back to that then updated to .500 again, knowing a little about software, makes me feel very uneasy about this whole machine and its programming. |
|