Updated the latest firmware, after the update was completed and the aircraft was restarted. the "Aircraft Status" page

shows the following:

Overall Status                "updates Required"  (this is in the place that normally reads "latest Frimware")

??

When i select this it takes me to a blank page and no message or instructions.

Help?

It refers to the firmware of the RC. Please make sure that you have WiFi access, touch the "Update required" button and follow instructions on the screen. It will take just few minutes.

i thought i had done that and nothing seemed to happen.  Just be more patient and wait longer????

no further instructions when i touch "updates required" - just a blank page.

DJI admin - help

Just tried turning the aircraft on and touching the screen for the "updates required" and once it came up with a message "IMU   initialisation, do not touch the aircraft etc" but that didnt stay on screen for long and now the screen is blank

Aussie4220 Posted at 2017-3-8 15:52
Just tried turning the aircraft on and touching the screen for the "updates required" and once it came up with a message "IMU   initialisation, do not touch the aircraft etc" but that didnt stay on screen for long and now the screen is blank

Download the Controller firmware to a MicroSD card and update.
http://www.dji.com/phantom-4-pro/info#downloads

i downloaded to a micro SD card (the "bin" file), placed it in the RC, touched the "updates reqd" message and .... nothing?  What am i doing wrong?

Same here. Keep getting Error 800 message

Have a look at this post on the P4P

Phantom 4 Pro+ contoller update error

Scroll down to the DJI admin - Natalia's post, follow it.  I just did it and it worked for me.

It is amazing that so many people don't follow directions. (not referring to anyone on this thread).

Thats it?  thats your contribution?  Just jump in and ridicule without helping anyone?  Do you just troll posts so you can leave your pearls of wisdom at the expense of others?  (Not referring to anyone on this thread).

Aussie4220 Posted at 2017-3-8 16:50
Have a look at this post on the P4P

Phantom 4 Pro+ contoller update error

Good to hear you were able to get it sorted.

DJI-Jamie Posted at 2017-3-8 22:43
Good to hear you were able to get it sorted.

Yes, thank you Jamie, should i do another IMU calibration now that i updated the RC as well?

Aussie4220 Posted at 2017-3-9 04:54
Yes, thank you Jamie, should i do another IMU calibration now that i updated the RC as well?

You don't absolutely need to, the app would let you know when it's needed. If you notice that the camera is a bit tilted upon start up, or anything like that, then do an IMU calibration and a gimbal calibration in that order.

DJI-Jamie Posted at 2017-3-9 13:19
You don't absolutely need to, the app would let you know when it's needed. If you notice that the camera is a bit tilted upon start up, or anything like that, then do an IMU calibration and a gimbal calibration in that order.

Thank you again for your help and prompt response