I recently got my Phantom 2 Vision+ and calibrated the remote controller using the PC assistant. Since then, the gimbal control returns the camera to the 'up' position immediately after panning down and...help!?!

You need to provide more info for someone to help you. Firmware etc.

Main controller 3.08
Receiver 5.8G 1.0.1.3
P330CB 1.0.2.10
Zen IMU 1.0.0.6

Go into the advanced menu, under the gimbal tab make sure the vertical limit is set to zero.

I haven't that option.

sorry! wrong pic!

This is what I wanted to show...

smurfscent.gmai Posted at 2015-2-26 07:52
This is what I wanted to show...

Sorry I saw the Zen IMU rev and thought you had a Zenmuse Gimbal on a Phantom 2.

Did you also calibrate the gimbal in the RC System Assistant 1.2?

Ya, same issue. The camera doesn't retain it's position & shoots back to straight forward.

You calibrated the sticks AS WELL AS the gimbal scroll wheel? It's the X1 channel identifier in the RC assitant software.

Yup. Did that.

http://youtu.be/TbwvbmB5r3w

After watching the video (THANK YOU!) I guess I must have been doing something wrong, as now it functions as it should! Thank you!