Samara1
lvl.2
Flight distance : 1037707 ft
United States
Offline
|
Ok, read and re-read this thread, and many others about gimbal troubles. Here's my story. Had a bit of an accident with my Inspire 1 Pro about a month ago, gimbal arm cracked, sent to DJI NYC, got replacement one about two weeks ago, flew this week, first two flights no issues. On third flight I noticed the gimbal was not centered on takeoff, landed, restarted everything, got a warning the firmware needed to updated, cancelled out of it, seemed ok but the gimbal had so how set to Free, set to Follow and flew flight no problems. Landed, went to new location, fired everything up and the gimbal went crazy, spinning around, whacking into the stops at full rotation then went limp, got the gimbal motor overload warning. shut everything down, then rebooted everything, checked firmware status for everything and all showed normal, gimbal spun around again, shut down went home! Been working on this for about two hours tonight, tried different gimbal board, made sure all cables secured, downgraded RC and then upgraded back to updated version. Nothing seems to work. I get a video feed but sometimes I get a gimbal disconnect warning but can still see video feed. Throwing in the towel tonight, calling DJI NYC in the AM...frustrated...Screenshot of firmwares attached. What does the + mean after the 1.11.01.50 in the screenshot? Thanks, John |
|