bernde
 lvl.3
Austria
Offline
|
Hello,
I installed my new N3 in my copter, after that I updated the firmware to the last version. But I had a problem during the update, because the Compass was not connected right.
Does the compass need to firmware update?
If yes, how can I update the compass alone, because when I try to Update it with the Assistant software, it says, that there is no update.
Now I wanted to calibrate the compass, but it always tell me that there are magnetic interferences. I tried it in my garden with only the notebook connected, but the same issue!? How can this be solved?
Kind regards,
Bernd
|
|