fans8365306c
New
United States
Offline
|
Hey all!
I took my Phanton 2 off the shelf and am trying to get it running again. I have the Zenmuse H3-3D gimbal and the iOS Mini connected to my GoPro 4 Black. I updated the GoPro Charged everything up and did a trial run. The Phantom fired up and I got into the air. Didn't go too high cause I was just testing. Light's started flashing red and then it preformed a "return to home" move. Also I couldn't get the RF video signal to come through on the Elvid Skyvision monitor. So I shut everything down and then restarted with all the same exact results.
I feel I need to see if there's some better firmware update to install. But to do this I need the software to interface with the unit. I cannot find any suport for the Phantom 2 on the DJI website. Also if someone has a link to the manual, I'd appreciate it.
Any and all suggestions would be greatly appreciated. Thank you
|
|