Today I tried my first flight after my mavic returned from service for the "gimbal overload problem".

First flight "VISION SYSTEM ERROR", off-on and everything went ok.
Second flight "VISION SYSTEM ERROR", off-on, VISION SYSTEM ERROR disappeared. And... GIMBAL OVERLOAD! ...
Clank sound (from gimbal) and then everything went ok.

... i don't know. I'm not very happy.

I will see during next flights.

You may have to calibrate vision sensors, pity because this should be checked before it left repair centre.

Please try to do the VPS calibration and do the gimbal calibration then test again.

i'm trying @DJI Mindy ...

but DJI Assistant has several problem with W10.
I had a problem with the driver (resolved, disable FW, disable trusted driver, ecc... not standard procedure at all) and now I'm trying to resolve the "Frame Alignment Error"...

maybe my laptop isn't a supported device

flyingasd Posted at 2017-4-9 23:31
i'm trying @DJI Mindy ...

but DJI Assistant has several problem with W10.

Maybe you could borrow your friend's computer to have a try?

@DJI Mindy see this thread: https://forum.dji.com/thread-87373-1-1.html
for installing DJI Assistant this one: https://forum.dji.com/thread-88182-1-1.html (and other threads)
i'm not alone (as usual )

i'm an IT so i fix problems by myself, but i don't know what a newbie can do when had problem with his mavic

the funny thing is that the mavic is a fantastic piece of hardware, but the software counterpart... it's a nightmare!
P.S.: i'm pretty sure that if I downgrade to v01.03.0400 i will not have problem with VPS...

you would think that they would have test and done all the required calibrations before sending it.  quality control seems to be almost nil

I did the calibration again but at first flight (with .600) I had the same problem.
Mavic continues to avoid invisible obstacle on his way...

.............................