Lam47
lvl.1
United Kingdom
Offline
|
Hey. Thanks for the reply.
It has done this since we bought it. I have replaced the external wiring as it was also spinning like crazy if the roll hit near to 90 degrees. Seems the t junction on the roll is rather delicate.
The new cable had a right angle rather than coming straight out of the junction, so it will not get damaged so easily.
Have tried re setting and calibrating yes. We have the tilt trim to -10 which leaves us about 4 degrees off level.
Changing stiffness and deadpan/turning off smoothtrack seems to make no difference.
It's a shame as when the gimbal is turned on it sets to perfectly level. Then the tilt moves after a couple of seconds to not being level. It's odd as the roll is perfect. It sets to 0.002 ish which is amazing.
I'm not sure why the firmware does not think the tilt should default to 0. It always wants to set at an angle of about 13 14 degrees (Without the trim set to -10)
Thanks. |
|