sam
lvl.1
Australia
Offline
|
Hi,
s900, A2, Lightbridge, Futaba remote. I'm up to my 4-5th flight. Everything good until now!!
Had a 6m fall, Not sure what happened, was in GPS mode, aircraft took a home point- I took off after 30 secs hovering at 2m, s900 went up super fast to 6m and it kept going up and down really fast, with no control from me. A2 went into failsafe, led went into blue flashes, but it kept going violently up and down for about 10 secs (not windy either). I flicked it to manual (as I figured something was up with the GPS), but it was too late- dropped straight down breaking a landing skid, arm mount and a couple of arm clips/propellors.
Whilst I wait for parts I've fixed what I can to just test a few things, without taking it off the ground. the s900 on motor start up vibrates more than usual (this i assume is because of the cable-tied- cracked arm mount). Doesn't seem to be any other damage to frame, or any other components. No errors come up for the components in A2 Assistant software.
I feel though that the source of the problem may have something to do with this GPS unit.
Today, when I plugged battery in (without starting motors up)- in GPS mode, it searched for satellites (3 red flashes), but then it goes to a steady pink, green, pink, green, repeatedly. When I switch to manual, I get blue flashes, and then if I go back to GPS mode it just stays on the blue flashes. Now, when I start up it is just blue flashes. (tried a GPS recalibration- didn't work)
Can some-one tell me what both these led indicators mean? and what is my next step?
Cheers
|
|