Hi everyone,
I recently got a great deal on an Inspire 1 with two controllers on eBay and it is a fantastic drone!  I have managed to get the firmwares updated to the latest versions on the controllers and the drone but I am having difficulty getting them working.  Whenever I request control of the gimbal on the slave controller it controls the entire drone, not just the gimbal.  Any ideas what could be causing this behaviour?

Thanks in advance.

Alistair

Make sure  the master controller has coach mode turned off.

Rich

Thanks Rich that was exactly the problem.

Advocate Posted at 2017-4-19 14:33
Thanks Rich that was exactly the problem.

You are welcome my friend!

FYI    If you edit your tittle and let people know that this subject is   ((Solved))

Glad you have things going again.

Rich

Advocate Posted at 2017-4-19 14:33
Thanks Rich that was exactly the problem.

Good to hear it got sorted.

Advocate Posted at 2017-4-19 14:33
Thanks Rich that was exactly the problem.

Thanks for that little tip too!  I didn't realise I could edit the title.

Advocate Posted at 2017-4-20 03:23
Thanks for that little tip too!  I didn't realise I could edit the title.

Nice work, I just thought that others with the same problem can  find this post later....

I see this being helpful when you are searching the forum postings for information

Have a great day
Rich