When I bought my P3S the latest FWV was 1.06.8 which was showing some issues. I have been running on V. 1.05.7 for some time with no issues. Now I wondering if I might benefit from the latest Ver. Say your piece if you care to, I'd like to hear your opinions.

Thanks

I´d upgraded to 1.08.10 and after the upgrade had a weak signal issue only one time. It was hovering on place in distance over 100 meters and 5 secs the signal was strong again. From that day the status bar was always solid green. The distance i tried was more than 300 meters and i did not lose the RC signal to the copter. This version might be stable.

I've had nothing but problems since I updated to latest firmware in mid January...

1.08.10 working fine here since release. Works with PapaTita mod too. Not using any hardware boosters

Axor11 Posted at 2017-5-1 02:47
I've had nothing but problems since I updated to latest firmware in mid January...

Like wise for me and a lot of others, constant interference warnings, very annoying.

Are your RC and AC AS the mobile device too close together?

Peterx Posted at 2017-5-1 05:17
Are your RC and AC AS the mobile device too close together?

??????????????

DJI has really poor support now on Phantom 3 since they are no long manufactured.........

Peterx not sure what u mean

after update cant fly any higher than 30 metre and cant fix it   

No good here as well.

The most mobile devices have strong static and dynamic EM fields and can interfere the RC/AC link and let the compass stuck.  I separate the AC and RC up to 3-5 meters and the mobile device is nearest 1/2 meter far from the RC.

Will try that pererx..

Hinosaur Posted at 2017-5-5 15:02
after update cant fly any higher than 30 metre and cant fix it

check to see if it set it back to beginner mode in the settings