When I use intelligent modes, the DJI GO4 application no longer responds to my commands, freezes and sometimes restarts automatically or else I need to turn off and turn on the remote control. Is the problem stemming from the firmware? I would like to point out that I have installed the latest firmware available.

Did the issue occur right after the firmware update, or was it working a few times after the update?

http://forum.dji.com/thread-94489-1-1.html

Breslau 1976 Posted at 2017-5-3 03:03
http://forum.dji.com/thread-94489-1-1.html

Do you need to hijack other threads with your link (at least 6 ) ? You've already posted your problem, this is a public forum so you will just have to wait until somebody replies.

i try to resolve some problems, like i see there is allots of this  about. so  some people can try this metod.  after last one  update firmware. did you have some problems  whit this?
did you resolve any problem?

DJI-Jamie Posted at 2017-5-2 20:00
Did the issue occur right after the firmware update, or was it working a few times after the update?

I found that while using the "Draw" mode, the DJI GO application does not work properly, it no longer responds to my commands, by mistake the height and speed data of the aircraft, and sometimes it restarts the system. Is this problem due to firmware?