Shocker
New
United States
Offline
|
After many internet searches, and attempts to resolve my camera issue, I finally figured it out, and decided to share my solution since it was hard to come by. Upgrading to IMU Firmware version 1.0.0.6 appeared to break the app's control of the camera, and my camera always wanted to point down. Turns out version 1.0.0.6 didn't break anything, but it added capability for newer, more upgraded accessories like the RC remote. I doubt everyone knows there is more than one remote compatible with the Phantom 2. Anyhow, it appears the IMU firmware update set the default for a newer remote control that I didn't have and perhaps screwed up my calibration for my control. My solution was to connect the Phantom 2 via USB port, launch the Phantom 2 PC Assistant 3.8 software, go to the RC tab under the Basic settings, set my transmitter (PVT581) back to the Basic Version, and do the X1 Calibration. They say the X1 channel is for the gimbal pitch control. Hope this helps someone else.
|
|