TheCyberKnight
lvl.4
Canada
Offline
|
I have both the Spark Fly More and the Goggles.
The goggles do work with the Spark but not all features are supported. When used with Spark, you need to have the RC since the goggles require the OTG cable to connect.
Right now, this is working fine:
- the video feed is properly sent to the goggles
- the full avionics information is displayed in real-time
- the reported gimbal angle position is relevant
- the information on the video feed format is right
- the warning messages are properly relayed to the visor
Here are 2 major issues I found:
- Once you reach the low-battery level (the one previously set with DJI Go 4), you get a pop-up window advising you that return-to-home will be initiated in 10 seconds. You can either "confirm" or "cancel" using two buttons that you select with the touch pad. The problem is that the "cancel" button does nothing, whatever the number of times you select it. You therefore end-up with a forced return-to-home. This flaw cost me a minor crash as the Spark started to ascent to its RTH altitude but was underneath a large tree at this moment. Fortunately no damages.
- For some reason, once connected to the goggles, the Spark remote buttons controlling the video and picture taking just stop working. Their only use at this point seems to change the resolution at which the video feed is sent - to match the resolution mode used by the camera. It was not able to ever take a picture or start filming with either the remote control or the goggles UI. This could be a firmware issue but as of now, this single issue makes the goggles totally useless.
I guess most of these problems will disappear once the goggles firmware is updated to officially support Spark.
|
|