I've had my P4P for about 4 months now, and each time I update the firmware using the Assistant app on my Mac (with current OS) I try to go through the calibration that is in the Assistant.  However, everytime I run into a problem because there are no images shown on the Assistant for me to work with.  I just get a blank screen.  I've tried to move the drone various distances from the screen (right up close, then about 2 feet away, and everything in between), but I never see the the graphics that I should be using for the calibration.  (By the way, the basic 3 step training IS shown in the beginning.)  I do have the drone connected through the USB cord.  

Also, does this calibration achieve the same results as the calibration shown in GO 4?

Any help would be appreciated.

I've had my P4P for about 4 months now, and each time I update the firmware using the Assistant app on my Mac (with current OS) I try to go through the calibration that is in the Assistant.  However, everytime I run into a problem because there are no images shown on the Assistant for me to work with.  I just get a blank screen.  I've tried to move the drone various distances from the screen (right up close, then about 2 feet away, and everything in between), but I never see the the graphics that I should be using for the calibration.  (By the way, the basic 3 step training IS shown in the beginning.)  I do have the drone connected through the USB cord.  

Also, does this calibration achieve the same results as the calibration shown in GO 4?

Any help would be appreciated.