I use the Goggles with a P4P using the usb cable.
Flying while filming in PAL the image in the Goggles is realy showing uge delays.
If I switch to NTFS there is almost no delay.

Just to verify,  P4P or P4P+? How long has it been delayed? Please tell me the firmware version of the drone and RC. Do you have the same issue when you use the drone without the Goggles?

DJI Diana Posted at 2017-8-19 22:08
Just to verify,  P4P or P4P+? How long has it been delayed? Please tell me the firmware version of the drone and RC. Do you have the same issue when you use the drone without the Goggles?

P4P. The delay is a few seconds. The Phantom, remote and goggles are running the latest firmware.
And to be clear the delay is only on the goggles and not on the phone or tablet.

DJI Diana Posted at 2017-8-19 22:08
Just to verify,  P4P or P4P+? How long has it been delayed? Please tell me the firmware version of the drone and RC. Do you have the same issue when you use the drone without the Goggles?

P4P. The delay is a few seconds. The Phantom, remote and goggles are running the latest firmware.
And to be clear the delay is only on the goggles and not on the phone or tablet.

Kingii Posted at 2017-8-20 08:01
P4P. The delay is a few seconds. The Phantom, remote and goggles are running the latest firmware.
And to be clear the delay is only on the goggles and not on the phone or tablet.

Thanks, I've forwarded it to our engineers for analysis, will keep you updated.

Kingii Posted at 2017-8-20 08:01
P4P. The delay is a few seconds. The Phantom, remote and goggles are running the latest firmware.
And to be clear the delay is only on the goggles and not on the phone or tablet.

There was another Goggles update yesterday (V1.3.1000), that may help.

Aardvark Posted at 2017-8-23 14:08
There was another Goggles update yesterday (V1.3.1000), that may help.

Thanks. I will check and test later today.
I will post the results.

Kingii Posted at 2017-8-23 22:57
Thanks. I will check and test later today.
I will post the results.

After updating the firmware of the goggles it looks like the delay is less. Although I haven't tested it flying. I only tested it from my desk.
Taking pictures however result in unwanted movement of the camera/ gimbal to the left/ lower corner.
After reconnecting the remote to my iPhone and Go4 app the issue,  'Taking picture results in losing signal and gimbal movement', reported in the post below is back:
https://forum.dji.com/thread-108052-1-1.html

So, it looks there is still some bugfixing to do.

Hello, thanks for your detailed information.

Our engineer is now investigating into this issue, and will optimize the delay in latter firmware.

neonadler@hotma Posted at 2017-8-30 05:28
Hello, thanks for your detailed information.

Our engineer is now investigating into this issue, and will optimize the delay in latter firmware.

My pleasure.
Hope it will be fixed in the next update.