Hello,

we have two Ronin mx with the same problem:
When we fly the Ronin mx both behave like smooth track for roll an tilt was ON though it is definitly off. Copter rolls -> Ronin follows, copter tilts -> ronin follows. This is in free mode, definitly not in fpv mode.

?

This is with org. radio and with external receiver and futaba radio.
All are on the latest firmware.

We fly them with a big octocopter (kraken130), A3, Connex, Futaba.

We have not yet coonected the Ronin mx to the A3 via canbus. The same setup works flawlessly on a 21ft crane and buggy. Handheld both Ronins too work perfectly too when operated via radio.
As soon we are in the air we have this behavior. This is not a small horizon drift. We can not work with this setup.

Every idea is highly appreciated!!!

Best regards

We found no way to let the Ronin mx communicate with the A3 via canbus when using an external (Futaba) receiver.
Is there anybody who is actually flying the Ronin mx with the A3 without Lightbridge?

We have two Ronin mx who behaive like in smoothtrack when in the air. We can not work with this setup.

Any idea is highly appreciated!

Best regards

Hi, sorry to read on this issue. Can you provide a video on what you are seeing?

Have you tried any type of system calibration with the Assistant Software? You can get that software here: http://www.dji.com/ronin-mx/info#downloads