Does anybody know in which frequency the Master-Slave link works?

They work on 5.8G.

DJI Mindy Posted at 2017-9-24 23:51
They work on 5.8G.

Thanks Mindy. I'd like to understand this a little better:
Is the Slave RC communicating with the aircraft at all, or is all communication (gimbal control and down-link) all achieved via the Master RC?
Kind regards
Allan

allanart Posted at 2017-9-24 23:56
Thanks Mindy. I'd like to understand this a little better:
Is the Slave RC communicating with the aircraft at all, or is all communication (gimbal control and down-link) all achieved via the Master RC?
Kind regards

For Inspire 1, the Slave RC gets image transmission from the aircraft directly, but it receives gimbal control from Master RC.
For example, when the Master RC is turned off, the drone will enter RTH, slave RC cannot control gimbal but can still receive image.

DJI Mindy Posted at 2017-9-25 00:21
For Inspire 1, the Slave RC gets image transmission from the aircraft directly, but it receives gimbal control from Master RC.
For example, when the Master Slave is turned off, the RC will enter RTH, slave RC cannot control gimbal but can still receive image.

Thanks, but how about the case for the Inspire-2?
Regards
Allan

DJI Mindy Posted at 2017-9-25 00:21
For Inspire 1, the Slave RC gets image transmission from the aircraft directly, but it receives gimbal control from Master RC.
For example, when the Master Slave is turned off, the RC will enter RTH, slave RC cannot control gimbal but can still receive image.

I assume you mean Master RC, not Master Slave?

Mark G.

allanart Posted at 2017-9-25 07:20
Thanks, but how about the case for the Inspire-2?
Regards
Allan

Mindy's explanation would be applicable to an Inspire 2 as well.

DJI-Mark Posted at 2017-9-25 08:07
Mindy's explanation would be applicable to an Inspire 2 as well.

I´m sorry, but the slave RC of the i2 receives control and video from master RC only. Double checked.
Different from the i1

Mark Guille Posted at 2017-9-25 07:26
I assume you mean Master RC, not Master Slave?

Mark G.

Sorry, my bad, the post has been modified.

Ale Reynoso Posted at 2017-9-25 19:20
I´m sorry, but the slave RC of the i2 receives control and video from master RC only. Double checked.
Different from the i1

Sorry, you are right, Slave RC of Inspire 2 is different from Inspire 1, it receives image and gimbal control from Master RC.

allanart Posted at 2017-9-25 07:20
Thanks, but how about the case for the Inspire-2?
Regards
Allan

Have replied in 10#, please check.

DJI Mindy Posted at 2017-9-26 02:03
Have replied in 10#, please check.

All clear now - thanks!
Allan