I can't find this information, but what size range is the standard mobile device holder for a P4A controller?
Like what devices can it hold without having to purchase a separate holder?

Thanks in advance,

Peter

The maximum width is 170mm. For the mobile device that the width is less than 170mm is available to hold.

DJI Susan Posted at 2017-10-17 19:28
The maximum width is 170mm. For the mobile device that the width is less than 170mm is available to hold.

Thanks. And what is the minimum (I have an iPhone SE but can't find if it will fit the default holder)

Montfrooij Posted at 2017-10-17 23:17
Thanks. And what is the minimum (I have an iPhone SE but can't find if it will fit the default holder)

Aloha Peter,

     For the smaller devices, there are little arms that come out kind of in the middle of the holder on each side.  They are up about two inches from the main bottom flat with the notch in the middle.  You may have to work between the two.  The largest tablet I have used is a Samsung 10.1 inch.  It just barely fits.

     Hope this helps!

Aloha and Drone On!

Cetacean Posted at 2017-10-17 23:47
Aloha Peter,

     For the smaller devices, there are little arms that come out kind of in the middle of the holder on each side.  They are up about two inches from the main bottom flat with the notch in the middle.  You may have to work between the two.  The largest tablet I have used is a Samsung 10.1 inch.  It just barely fits.

Thanks, and these arms go up all the way? So a iPhone SE won't be an issue?

Montfrooij Posted at 2017-10-18 01:10
Thanks, and these arms go up all the way? So a iPhone SE won't be an issue?

Aloha Peter,

     When the phone size devices are used in the display mounts, with the two arms out, the phone sits about two inches above the bottom that is used with tablets.  There are some photos of it being used on YouTube and the DJI sites.  The two arms will hold the side of the phone facing down.

     Hope this helps!

Aloha and Drone On!

Montfrooij Posted at 2017-10-17 23:17
Thanks. And what is the minimum (I have an iPhone SE but can't find if it will fit the default holder)

Peter, iPhone SE is one of recommended mobile devices of P4A, no need to worry about this.

Cetacean Posted at 2017-10-18 01:23
Aloha Peter,

     When the phone size devices are used in the display mounts, with the two arms out, the phone sits about two inches above the bottom that is used with tablets.  There are some photos of it being used on YouTube and the DJI sites.  The two arms will hold the side of the phone facing down.

Thanks for the confirmation.

DJI Susan Posted at 2017-10-18 01:58
Peter, iPhone SE is one of recommended mobile devices of P4A, no need to worry about this.

Thanks for the confirmation.
Where can I find this recommended list?

Montfrooij Posted at 2017-10-18 03:38
Thanks for the confirmation.
Where can I find this recommended list?

You can view it on the official website, APP / LIVE VIEW: http://www.dji.com/phantom-4-adv/info#downloads

DJI Thor Posted at 2017-10-18 03:53
You can view it on the official website, APP / LIVE VIEW: http://www.dji.com/phantom-4-adv/info#downloads

Thanks. I missed that one.