Hello,
I have a Z30 that I use on my M600Pro's, I have an issue where the Z30 'Freezes' then resets. I have the current unit in for repair, but wanted to see if anyone has seen this issue whlie using the Z30 on any other DJI platform. Before sending the Z30 for repair, I conducted lots of test to eliminate the Z30 (see below), I recorded the DJIGo app screens and had uploaded for them to review.
If anyone has had this issue please let me know.
<snip>
Here is the what I did to ‘test’ this issue with the Z-30.
- I have 2 M600 Pro’s (1 with D-RTK, and 1 without D-RTK).
- I have 2 CrystalSky High Brightness (7.85)
- I have 2 iPad Pro’s (2016 model, 9.7 inch)
- I have 1 mounting bracket for Z-30 (I move it from one M600 to the other for testing)
I tested the Z-30 this way:
Test 1: - First M600 Pro (the one with no D-RTK system).
- CrystalSky #1
- Z-30 (Firmware version .37)
Test 2: - First M600 Pro (the one with no D-RTK system).
- iPad Pro #1
- Z-30 (Firmware version .37)
Test 3: - Second M600 Pro (the one with D-RTK system).
- CrystalSky #2
- Z-30 (Firmware version .37)
Test 4: - Second M600 Pro (the one with D-RTK system).
- iPad Pro #2
- Z-30 (Firmware version .37)
Test 5: - First M600 Pro (the one with no D-RTK system).
- CrystalSky #1
- Z-30 (Firmware version .43)
Test 6: - First M600 Pro (the one with no D-RTK system).
- iPad Pro #1
- Z-30 (Firmware version .43)
Test 7: - Second M600 Pro (the one with D-RTK system).
- CrystalSky #2
- Z-30 (Firmware version .43)
Test 8: - Second M600 Pro (the one with D-RTK system).
- iPad Pro #2
- Z-30 (Firmware version .43)
I got the same results (Issues) with all the tests, the Z-30 works for about the first 5 minutes of the flight and then starts to reset (complete reset back to factory defaults). Every time I take a picture or try to start video, it resets. Tap Zoom fails on the Go App, Manual Zoom using the remote controller works, but camera still resets.
<snip>
Thanks.
|