Hi folks,

Hoping you can help... No matter what I try I can't seem to get the tilt wheel to smoothly move the HD-3D gimal!


I can move it between shoots and it moves between min and max angles fine. It also stablises the image as it should. However, say I'm flying over something and want to pan the camera to look down, it's always an intial "jerk" when the gimbal moves and spoils the shot!


I tried changing the "Tilt Control Gain" but this makes absolutely no difference. Some say this is because I'm in Naza mode?

Any tips? Phantom 2 / HD-3D all firmware is up to date. Gone through all of the calibrations... please help!

Al

follow this to the letter and your camera wheel will operate smoothly.

Gerry my friend, if that works, I will love you. I'll try tonight

Finally got around to trying this (managed to crash my phantom into a pole and needed a new Gimbal!).... anyway, the problem was present with the new gimbal until I followed that guide.

Thanks again!
Al

YeKen Posted at 2015-4-20 23:01
Finally got around to trying this (managed to crash my phantom into a pole and needed a new Gimbal!) ...

So, you're back up and working ok?

Good to hear
Happy Flying!

Yep! Big thanks

Gerry1124 Posted at 2015-4-15 03:22
follow this to the letter and your camera wheel will operate smoothly.

Dude you are the man. ive done so much searching. figured this would never work as ive tried many different things. My hd 3d works perfectly now. full range of motion and not chattering at all. thanks again

Gerry1124 Posted at 2015-4-15 09:22
follow this to the letter and your camera wheel will operate smoothly.

is there a similar remedy fr the phantom 3 4K please? I have the same issue