Hey yall, So i just finished my first build. F450 with the E305 2312 960kv 420lite kit.
Naza V2 FC.
Zenmuse H4-3D
FrSky QX7s TX and X4r-sb RX.
Tattu 4s 3700 Li-po
The issue I'm running into has been discussed hundreds of times and I've followed all the guides about installing the drivers in test mode or deactivating security protocals.. yadi yadi.....but still no go
I can install the driver on my computer (Windows 10 fall creators edition) in test mode but it tells me the driver is already up to date. I belive its 2.02 (see attached pics). The assistant does the normal load 3/4 then skip to enter, then nothing, no Tx/Rx input no red or blue lights on assistant. Naza led pale green when connected USB.
Rx/Tx are bound, solid green light on X4r.
Also the unit will not arm, If I power the FC led will blink orange, I then power TX, Rx/Tx bind, Naza led goes 4 fast red. Batteries are at 100%. Unable to access assistant to change low voltage alarm or setup anything.
Addit info
X4r is ran Sbus to X2 on FC made sure positive and negatives are correct
X3 on pmu ran to X3 on FC
lvl.2
