I have had this set-up for several years but hav'e been flying it.
For some reason, the 'Assistant' software isn't communicating with the xmitter and I don't understan why.
The xmitter is still in control of the drone and my computer "chimes" when I plug it in but when I click on "Phantom" in the Assistant app, it says "ERROR, Please connect to the controller".
Any ideas what might be going on here?
Alex

Sorry, correction. Plugged into The receiver.

Alex, could you upload a short video for better assistance? I'm sorry I'm a little confused.

Try connecting the PC to the Phantom, not the controller/transmitter

Discovered that I was probably using the NAZA Assistant in the past however can't seem to get that to communicate either.
Have a look here, please.
Alex

Still no luck with comms to the computer.
As I recall, the green light should be on when properly connected however, as you see, it is only partially on and, even more faint is the red LED.
I have gone through every USB cable I have without luck however, my computer "chimes" when I hook up the NAZA.
I don't know what else to try.

Faint Green