I recently received FW1.11.30 from Susan to fix my 2 phantoms with ESC errors. The first aircraft upgraded successfully on first attempt, showing FW1.11.20+ in the djigo 'about' window. The second aircraft goes through the process successfully every attempt, with the solid green light at the end and the beeping noise that lets you know it's done. When I connect to DJIgo the 'about' window is showing FW1.11.20+ yet when I attempt to arm the aircraft I get ESC error still. I've attempted the update at least 5 times, each being successful and i've even delayed about 10mins after the completion beep before powering down the aircraft. The firmware result file in the sd card reads 'success' for each attempt.

Any suggestions would be greatly appreciated, thank you. (mean while i'll continue with the attempts)

I recently received FW1.11.30 from Susan to fix my 2 phantoms with ESC errors. The first aircraft upgraded successfully on first attempt, showing FW1.11.20+ in the djigo 'about' window. The second aircraft goes through the process successfully every attempt, with the solid green light at the end and the beeping noise that lets you know it's done. When I connect to DJIgo the 'about' window is showing FW1.11.20+ yet when I attempt to arm the aircraft I get ESC error still. I've attempted the update at least 5 times, each being successful and i've even delayed about 10mins after the completion beep before powering down the aircraft. The firmware result file in the sd card reads 'success' for each attempt.

Any suggestions would be greatly appreciated, thank you. (mean while i'll continue with the attempts)