Hi everyone
Hope ya all well!
Wondered if anyone clued up on repairing phantom 3 stand drones and can help me?
As bought brand new insides mother board,motors,lights ect from new drone...
Also had a cable ribbon replacement for gimbal camera.
Now all powers up ok but when camera connected seems to short drone out...lights goes off....
Soon as disconecct connection for camera liggts come back on and powers up ok..
Any help in this issue is much appruciated guys.

Kindest regards
Justin

Sorry...all powered up now but no video...any help much appriciated...

Ok you mentioned it all shorts out when you connect cable ribbon but now its all working with no video correct ?
If that is the case then its posible that it was the camera causing the short.
May i ask what has caused such an exstensive repair job?
Have you done latest firmware update ?
I think there is an issue currently with no video feed if you ask an admin/mod they can send you an update that may help

Good morning hellsgate
Thank you for your reply my friend!

Yes correct,all powers up and once ribon cable connected it all shorts out!
Yes it did just fall out sky and smashed camera completley off..
So bought new full inside for drone..mother board,lights ,motors all brand new hellsgate...
Have not done any firmware updates,,do you think that could be  A solution?
Thank you so much for your post my friend,really appriciate your help..
Kind regards
Justin

Just a update,incase anyone intrested!!
Well tried again & tried a update & will not accept update

So looks like i have to give up on this drone alltogether...
Wouldnt mind waited a long time for parts from usa (im in uk) gutted!!
Hope i can return board...
Take care
Justin

Also saying battery error now....
Going from bad to worse guys...

You could always send it to DJI for a repair, or at least a quote, can be quite favourable sometimes

Hi bashy
Hope your okay pal...
Thank you for your post..
To b honest i dont want to spend anymore money on it as had new board and gimble arm and ribon wire & new motors etc...
Sonits a case of if it dont work this baby is getting stripped down and sold as parts...

So any ideads really would b appriciated anyone...

Kind regards
Justin

Sorry to post again giys but going to start new post to see if i can get a bit of attention or any ideas as some people just read first post and problem changed...
Thank you for any advise..

Kind regards justin

Just a update guys...
Gave up now & getting sripped...end of life for that drone....
Thanks for help
Kind regards
Justin