No Image Transmission is appearing and thus no picture showing up on the iPad/RC. Tried this with 2 cameras. Must add that I just upgraded the software & firmware. Am thinking it's a glitch. Have seen other posts about this in the past and played with the Bandwidth slider on the HD tab of Settings ... no change. Any ideas?

Regarding your issue, please kindly check the methods below for troubleshooting.
1. Please check the HD setting in the DJI GO app, adjust the parameter of Transmission Quality to the middle, and change the APP Output Mode as "EXT".
3. Please try to change another mobile device and connect.
If it still does not work, to help you further, please provide us the following information.
- Video of operation and its problem
- Screenshot of version interface
- Screenshot of HD setting interface
- Type and Version of mobile device
- The cameras you have tried

DJI Mindy Posted at 2018-4-24 01:16
Regarding your issue, please kindly check the methods below for troubleshooting.
1. Please check the HD setting in the DJI GO app, adjust the parameter of Transmission Quality to the middle, and change the APP Output Mode as "EXT".
3. Please try to change another mobile device and connect.

Thanks !!  Changing the App Output Mode to EXT did it. Cameras are working. That wasn't fun.

FYI,

Had the same problem and took a few hours to find out...

you stated :  'adjust the parameter of Transmission Quality to the middle'   do you mean the Bandwidth allocation (LB-EXT) ?
I'm installing this with a CS screen.
Is there somewhere a more elaborate  manual that explains this HD chapter?

Baltimoredrones Posted at 2018-4-29 05:50
Thanks !!  Changing the App Output Mode to EXT did it. Cameras are working. That wasn't fun.

Glad to know the issue was figured out, please let us know if there is any further issue.

djiuser_WZu12heKYQV2 Posted at 2018-5-3 23:33
FYI,

Had the same problem and took a few hours to find out...

Are you mounting Ronin-MX? If yes, you are right.