dsenechal
lvl.2
United States
Offline
|
I recently purchased a Matrice 600 Pro, using it with my older Zenmuse Z15 gimbal. The Matrice itself works properly, as does the controller, and the Lightbridge 2 (although I do not get a camera menu and cannot change the gimbal speed). HOWEVER, when I connect to the Assistant 2 software, the Lightbridge 2 display on the computer only partially works. It shows the firmware, however, when I click "Settings", it says Linking Air Unit which never changes. I've tried un-installing, re-installing, new cable, different computer, all the same result. Happens with both Windows 7 and Windows 10. This happens only with the Lightbridge side of the Assistant 2 - the Matrice 600 Pro works fine. Any ideas? Thanks.
|
|