Hi Guys,

I recieved my Mavic Air. Cuffed to hell

Setup, went well, upgrade to the 030 Firmware flew it a few times , then yesterday all of a sudden  Code 200 USB conection fault ?????.
Refusal to take off.

Tried all batteries same mistake.

Downgraded to all batteries to 020  Firmware, Violla , worked again....
But just one flight.

Tried again today, first i got the 200 code mistake. decided to go back to the 030  firrmware, now i get the description GPS fault and Internal sensors fault.
i have even tried the new DJI 4 Go software


Can anyone help ?

Hate to say it but I think you need to return it to DJI for replacement.

As 'A CW" says, I would return it.  Thus far the drone is intact and hasn't suffered a crash from whatever the cause of problem is.  
Continuing to try different firmware or whatnots - could get drone flying just long enough to wham-burger.  

HedgeTrimmer Posted at 2018-4-28 12:45
As 'A CW" says, I would return it.  Thus far the drone is intact and hasn't suffered a crash from whatever the cause of problem is.  
Continuing to try different firmware or whatnots - could get drone flying just long enough to wham-burger.

Thanks Boys... that was basically my conclusion as well,

thanks for the quick help

Contact them on monday morning

Sadly, agreed needs returning to DJI for repair/replacement.

You can try a firmware refresh before you pack it up and see if that helps but up to you for one last try.

rolling56 Posted at 2018-4-28 13:59
You can try a firmware refresh before you pack it up and see if that helps but up to you for one last try.

Thanks, but this is one of the several things that i tried.

Direct on my Laptop .

Thanks, anyway