AnyOne Else?
I am having problems connecting to craft! I have camera video, but no Stats of Craft or ability to use.
Says "Disconnected" in Big Red Box up top. Making no Sense!
All Firmware is up to date and have been flying!
Help!
I cannot be the only 1

Ok so what model drone are you trying to connect to?
So your getting the video feed from the drone but an error msg stating the drone is disconnected is that right?
The drone uses 2 different frequencies to do its job one is the flight controls and telemetry the other is the video signal.
Have you crashed the drone or had a hard landing if so then you may have damaged one of the antenea in the landing legs.

Hello, are you using DJI Go 4?  The "Ultimate Flight app" is not compatible.  

Hellsgate Posted at 2018-4-29 14:02
Ok so what model drone are you trying to connect to?
So your getting the video feed from the drone but an error msg stating the drone is disconnected is that right?
The drone uses 2 different frequencies to do its job one is the flight controls and telemetry the other is the video signal.

Thank you for the quick reply! It is a Phantom 4 and am using the  default settings for transmissions. No hard landings, but camera feed is there, it works in Go 4 but not in Ultimate Flight... Hope that helps you help me!

EpsonMoverio Posted at 2018-4-30 08:42
Hello, are you using DJI Go 4?  The "Ultimate Flight app" is not compatible.

I read that it is compatible with Phantom 4 and is paired with the Moverio BT-300 Glasses and was downloaded from the Moverio Store..........

Same problem here.
UFV3 downloaded from Epso store,
pretends to be Disconnected from P4 advanced,
but receives video.

As soon as I also installed DJI Go 4 from Epson,
video feed could not be received anymore.

I noticed also some quick Error message concerning Telemetry stream format.

I suspect incompatibility with latest P4 formware, but also between both Apps.