[size=14.6667px]Hello, I crashed my phantom 3 standard and it bent one arm of the shell and broke the gimbal ribbon and the camera came off of the arm. I replaced the shell and ribbon cable, the drone flies perfectly in atti mode but doesnt receive any GPS signal, sometimes it catches a few satellites but they quickly disappear and it disconnects from the app on the phone. The gimbal is dead and doesnt do the little dance and adjustment it did when the drone was turned on, it offers no resistance to turning the motors, yet the camera has a green light inside.
[size=14.6667px]The errors I'm getting in the app are Gimbal Tilt Error and Gimbal Roll Error, says hardware malfunction.
[size=14.6667px]The new shell came with the 2 little squares that i think are wifi and have tried both the new and original ones, same with the gps.
[size=14.6667px]Any help is appreciated.

Sounds like at least one and probably more circuit boards and maybe motors too.

Sorry to hear the troubles. The aircraft performance cannot be ensured after the crash and we do not suggest to disassemble at your end. I'd advise to start a case and send the unit in for diagnosis: https://www.dji.com/support