[size=14.6667px]Hey Guys [size=14.6667px]my phantom 3 advanced has updated firmware. 1.11.20
[size=14.6667px]but it says imu calibration require, whenever i try to calibrate. calibration halts at 2%. with a message unknonw error.
[size=14.6667px]please help. i flew this drone only once. n it was in cupboard for 8 months.
[size=14.6667px]please help.

Hi Trex.Drone, we apologize for the experience that you have with the aircraft. We would like to know, how many times have you tried to calibrate the IMU? is it placed on a leveled surface? Are there interference available? If we tried to calibrate it on different location with leveled surface and still the same, I highly suggest to send us the aircraft for analysis by clicking the link: https://repair.dji.com/repair/index.

DJI Natalia Posted at 2018-7-5 11:33
Hi Trex.Drone, we apologize for the experience that you have with the aircraft. We would like to know, how many times have you tried to calibrate the IMU? is it placed on a leveled surface? Are there interference available? If we tried to calibrate it on different location with leveled surface and still the same, I highly suggest to send us the aircraft for analysis by clicking the link: https://repair.dji.com/repair/index.

i tried many times.  z aix value at accelerometer stays at around -1.5.
the link you sent is broken.

Trex.Drone Posted at 2018-7-5 11:38
i tried many times.  z aix value at accelerometer stays at around -1.5.
the link you sent is broken.

please try the link https://www.dji.com/service/repair

Have you tried out to do a update on the firmware again? It could help. ..

Trex.Drone Posted at 2018-7-5 11:38
i tried many times.  z aix value at accelerometer stays at around -1.5.
the link you sent is broken.

Your avatar reminded me of the Align Drone.
http://www.align.com.tw/multicopter-en/m690l/


Align are the manufacturers of my TRex 700E DFC HV helicopter.

RedHotPoker

Hello there. We apologize for the inconvenience. Did you try to reinstall the application and do the calibration again?

hello , I´ve exactly the same problem with my phantom 3 pro

Same problem i don't use my drone since 6 months ago now imu calibration send error at 2% i already
Try Like 20 times  update the firmware 1.11.20, open the drone  hit the gyroscope nothing

DJI Natalia Posted at 2018-7-5 12:48
please try the link https://www.dji.com/service/repair

hello.
i tried wverything. even i opwnex the aircraft n tao imu. but still it stuck at z axis on -1.49
if iplace imu atside ways. then imu calliberation goes to 100%. but if imu is flat it doesnt calliberate more than 2%
i will swnd a drone. onky if i m sure u guys will change imy. i dont want to pay $200 for wholeboard.
n i hv no warranty cuz i hv opned my drone.
tell mw what u suggest. will u guys change only imu ?