I am using 6S battery settup on my drone and I am thinking if I can I use Zenmuse h-3d GCU v1 (standalone with out the gimbal) to power my Lightbridge 2?
The Zenmuse h-3d GCU v1 has a G8 connector.
Thinking if that would be ideal in stead og 12v BEC.

In sted maybe with my A2 6s setup is it ok to power the Lightbridge 2 with a bec I have. The nec gives me 12.25 volt, will that extra 0.25 volt do any hann to the lightbridge? It is rated 9-12 volt in the manual.

I would never take more than 12 V. Some time ago I have used an adjustable BEC with 9 V.
Best regards,
Wilhelm

WiSi-Testpilot Posted at 2018-7-9 12:02
I would never take more than 12 V. Some time ago I have used an adjustable BEC with 9 V.
Best regards,
Wilhelm

That is what I were thinking. But in the FAQ for the Lightbridge 2 is an answere from DJI that says that Lightbridge 2 is made for 3s wich is 12.6v full loaded.

12.6 V is a mistake. It was discussed on RC Groups a few years ago. A fully charged 3S Lipo will destroy your LB2.

WiSi-Testpilot Posted at 2018-7-9 13:42
12.6 V is a mistake. It was discussed on RC Groups a few years ago. A fully charged 3S Lipo will destroy your LB2.

Thanks for the info. My Bec that steps down from 6s to 12v is giving me 12,25v so I am sceptic about using that one also.