I have been having very frustrating signal problem. After replacing the landing gear on my inspire 2 the drone loses signal when he is facing the controller.
The signal is good when i'm flying the drone away fron me but as soon as i turn the drone in eather direction and he gets closer to facing the controler the signal starts to drop significantly.
Do you have any idea what could be causing this to happen ?
DJI Wanda Posted at 2018-8-8 09:33
Hello there. We apologize for the inconvenience. Is there any error message showing in the app? There might be some interference near you.
Hi thanks for the reply, no there is no error message and i have tested him in many places away from everything.
Apparently the receiving Lightbridge antenna pads in Inspire front legs are not correctly soldered back after replacement. This procedure is tricky and requires skilled soldering. That's my educated guess only ...
Matthew Dobrski Posted at 2018-8-8 11:50
Apparently the receiving Lightbridge antenna pads in Inspire front legs are not correctly soldered back after replacement. This procedure is tricky and requires skilled soldering. That's my educated guess only ...
Thanks for the reply Matthew , i will look into that and see if that is the problem.
Inspire quadcopters have four Lightbridge antennas installed squarely just below motors. Every antenna is wired to centrally located flight controller circuitry. If a connection is malfunctioning for any reason, it may cause radio transmission issues at certain aircraft heading(s).