Hello friends DJI users.

I have a S800 EVO : A2, IOSD MK2, Z15 gimbal and Datalink. My problem is that the bluetooth connection is impossible with my Ipad (ground station).

The Bluetooth connection is possible with the DJI Assistant. I CAN perfectly connect my Phantom 2 IOSD MK2 with my Ipad ground station.

All the tests I've completed indicate an incompatibility A2/Datalink.

Is there anybody with the same problem solved ?

Tanks to all.

What is the FW version on the A2 BTU ?

The A2 is fully updated and the BTU version is 2.0.

Thank you for your attention :-)

May I know where did you cennect the BTU to?

Hello,

The BTU is connected to the A2's PMU as shown in the attached file.

Thank you

m.Sauteraud Posted at 2014-9-24 19:57
Hello,

The BTU is connected to the A2's PMU as shown in the attached file.

Please connect the BTU to theGS groundlink when you using the iPad GS.

DJI-Howard Posted at 2014-9-28 11:05
Please connect the BTU to theGS groundlink when you using the iPad GS.

Thank you very much for your reply.
Do you mean that I must connect it physically because I'm unable (it's impossible)  to connect via Bluetooth.   :-(

DJI-Howard Posted at 2014-9-28 11:05
Please connect the BTU to theGS groundlink when you using the iPad GS.

I finally have found the problem : My seller connected the air end of the data link to my IOSD MK II via a can bus cable. The air end MUST be connected directly to the A2’s PMU as shown on the attached file.

Now, my data link works perfectlly with my Ipad and my S800EVO

I just thank you very very much because, I've been trying to solve this problem for several months with DJI, my seller... and you have given a good direction to investigate.

May I also add input to this and ask on the A2, can a Ipad connect to the BEC LED via Bluetooth?  I cannot and think it should.  The device is Bluetooth.