I have an Inspire 1 with 2 remotes. One is set up as master the other one as slave.
However I haven't been using the slave RC for quite a while. The master RC on the other hand has been used a lot. One of the antennas is a bit lose and I get the idea that the battery is not that good anymore.,Therefor I would like to switch the remotes. Making the master RC the slave RC and visa versa in the new set up. However I'n not quite sure how to do this. Anybody who has done this before ?

Hi. Thank you for reaching DJI Forum. Yes, that is possible to interchange 2 remote controllers of Inspire 1.

Is there a standard procedure to do this ?

Aerial Survey & Productions Posted at 2018-9-2 07:15
Is there a standard procedure to do this ?

Take a look in your RC settings in your GO APP.

Aerial Survey & Productions Posted at 2018-9-2 07:15
Is there a standard procedure to do this ?

You may refer to this one:

Thnx Wanda I'll look in to it.

And Thnx Mark