WebParrot
First Officer
Flight distance : 23625 ft
United States
Offline
|
HedgeTrimmer Posted at 12-1 19:35
Have you checked that voltages are compatible?
You might get close to find need jack by measuring outside diameter of "A" plug. Generally, plugs & jacks are referenced in mm (milimeters). Issue is what size is inside of "A". You need a wire-gauge set of drill bits to get inside diameter, using non-fluted (aka chuck end).
Below is an image of the specs for the Osmo Battery, the Mavic Pro Power adapter, and the Osmo Power Cable (shown in my post #3). Voltages of the battery and power cable are both 11.1V and the Adapter accepts a range of 9-20V.
I couldn't find and power demand/consumption specs on the Osmo. So I drew the conclusion that since the "Cable" provides a current output of 1.5A, the power source (the MP battery & adapter) at 2.0A would be sufficient. I realize this could be a flawed assumption :-) but it was something to start with.
Thanks for the suggestion to measure the diameters; completely fogged-over. I borrowed a metric caliper and measured the OD of another connector cable @ 7.36mm. The ID of the Extender is 7.35. [FWIW, I purchased a 10pin-a cable that is used to connect a Phantom 4 battery to the Extender]
Any other thoughts you have are welcomed, especially on the power cycle info. |
-
|