Apparently I can't finish this procedure. She went quickly thru 4 first steps and now sits on her side forever at last step. Green light is blinking quickly, status bar stuck almost at the end, but nothing else is happening ...

EDIT: after 25 min of senseless waiting I decided to move the drone and position it again in all possible configurations. All these movements were indicated by solid yellow light followed by fast blinking green once the drone was sitting steady. This did the trick and calibration was finally reported as successful. Sensors state page looks normal as well.

Apparently I can't finish this procedure. She went quickly thru 4 first steps and now sits on her side forever at last step. Green light is blinking quickly, status bar stuck almost at the end, but nothing else is happening ...

EDIT: after 25 min of senseless waiting I decided to move the drone and position it again in all possible configurations. All these movements were indicated by solid yellow light followed by fast blinking green once the drone was sitting steady. This did the trick and calibration was finally reported as successful. Sensors state page looks normal as well.